link href="https://fonts.googleapis.com/css?family=Open+Sans:400,600,700" rel="stylesheet">

Wasp v3 in a g36c
#3
(05-30-2017, 02:58 PM)admin Wrote: thanx 4 posting. the selector plate trim is kinda like the m4 install. how deep did you have to cut the channel?

I just cut the channel the same width and height as the original I just made it longer by about 1/8th of an inch or so. I'm about half way to full auto when it engages the switch. I just cut a little at a time until I was happy with the switching.
  


Messages In This Thread
Wasp v3 in a g36c - by Redskullss - 05-28-2017, 09:39 AM
RE: Wasp v3 in a g36c - by admin - 05-30-2017, 02:58 PM
RE: Wasp v3 in a g36c - by Redskullss - 05-30-2017, 10:20 PM
RE: Wasp v3 in a g36c - by admin - 05-31-2017, 05:04 PM

Forum Jump:


Users browsing this thread:
1 Guest(s)